Results 1 to 5 of 5
  1. #1
    Senior Member
    Join Date
    Jun 2013
    Location
    Sydney, Australia
    Posts
    606

    got to love SS wicks

    after reading a few posts and watching a vid on ss wicks i decided to try it, and must say am happy with the results
    hooked it up on my rsst but dam its sucks so much juice, seems to be using more than im vaping lol
    i mean was getting nice vapor and taste from mesh but a full tank would last me quite a while
    ive had this setup and gone through half a tank of juice in just over an hour
    i understand more im using more with this setup but that much?

  2. #2
    AVF Regular
    Join Date
    Jun 2013
    Location
    Adelaide, SA
    Posts
    285
    I'm having problems with hot legs on my RSST, did you have this and how did you remove it?

  3. #3
    AVF Regular
    Join Date
    Dec 2012
    Location
    Off grid, quietly hermity, NW Tas
    Posts
    6,476
    Bend the SS wick closer to the + washer, or replace the washer with a larger unit, or deploy a combination of both ideas.
    Make the connection point as close to the wick as practicable by moving the wick (output of the coil) or the connection point = reduced free air wire.


  4. #4
    Senior Member
    Join Date
    Jun 2013
    Location
    Sydney, Australia
    Posts
    606
    ye i basically did what was mentioned above, bottom coil i pushed with screwdriver to to make sure contact was at closest point and not looping out before coil wrap started, if that makes sense

  5. #5
    AVF Regular
    Join Date
    Jun 2013
    Location
    Adelaide, SA
    Posts
    285
    Thanks guys

 

 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Powered by vBulletin® Version 4.2.4
Copyright © 2019 vBulletin Solutions, Inc. All rights reserved.
Search Engine Friendly URLs by vBSEO 3.6.0
All times are GMT +11. The time now is 09:20 AM.