Results 1 to 4 of 4
  1. #1
    Member
    Join Date
    Aug 2013
    Location
    sydney
    Posts
    44

    Quick question about sub ohm

    So I've just started building my own coils and I've had a couple come out a little lower than expected.
    2 Evod heads that came in at 1 & 1.2 ohm (micro coils) and a coil on mesh in an AGI that came in at 0.8
    I tested the resistance on my flatmates Vamo as my Zmax wont even read that low, just says low load.

    All 3 work fine on my cheap mech clone with a 2c fuse and all fire on the Vision spinner 1300.

    The question is how safe are they to use on the spinner?

  2. #2
    AVF Regular
    Join Date
    Aug 2012
    Location
    Gympie Queensland
    Posts
    2,404
    Your spinner will most likely crap out on you if you go much below 1.2 ohms.save it for a higher ohm coil if you want it to last any time at all.
    Vaping since July 2012.

  3. #3
    T7x
    T7x is offline
    AVF Regular
    Join Date
    Aug 2013
    Location
    Queensland
    Posts
    1,319
    As studio said, not a matter of safety as the spinner has some protections in there but it will turn that 6 month battery into a fortnight battery.
    Do you know de way 👺

  4. #4
    Senior Member
    Join Date
    Jun 2013
    Location
    Fawkner, Victoria
    Posts
    1,111
    I recommend all clearomizers to be 1.5ohms or above, especially with Micro Coils as they heat up pretty hot so it may have a chance to burn the rubber insulator.

 

 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Powered by vBulletin® Version 4.2.4
Copyright © 2019 vBulletin Solutions, Inc. All rights reserved.
Search Engine Friendly URLs by vBSEO 3.6.0
All times are GMT +11. The time now is 02:58 AM.