Results 1 to 3 of 3
Like Tree6Likes
  • 2 Post By jeno1200
  • 1 Post By jeno1200
  • 3 Post By afxlol

Thread: Modified Magma

  1. #1
    AVF Regular
    Join Date
    Aug 2014
    Location
    Wollongong, NSW
    Posts
    370

    Modified Magma

    Found this on reddit and thought I'd give it a go because i wasn't using my magma (clone) because i was sick of it leaking juice out the air holes.
    Mine doesn't look as good as his but it seems to have stopped the leaking so far. So im happy
    I even installed a small o ring where the cap screws on.
    My first build after modification is 0.2ohm dual coil 6 wraps with 24AWG and the air control ring left off.
    here is the pic off reddit:



    If you do try it i won't be held responsible for a wrecked dripper
    Last edited by jeno1200; 05-10-14 at 07:22 PM.
    avtek and Pipesub like this.

  2. #2
    AVF Regular
    Join Date
    Aug 2014
    Location
    Wollongong, NSW
    Posts
    370
    Also i found out the hard way that if you are working on a atty you should remove the screws first and put them somewhere safe.
    I spent 1/2 hour looking for one of them in my garage.
    LimeB likes this.

  3. #3
    Junior Member
    Join Date
    Sep 2014
    Posts
    26
    I saw this post and a video of the guy using a dremel to do it and looked cool. I also saw a guy who inserted a low gauge syringe into the airflow holes on the deck to raise the opening a few mm higher which achieved the same thing but slightly lowered the airflow.



    I believe its a 12G needle to fit the holes snuggly.
    Attached Images Attached Images
    avtek, nukem and jeno1200 like this.

 

 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Powered by vBulletin® Version 4.2.4
Copyright © 2020 vBulletin Solutions, Inc. All rights reserved.
Search Engine Friendly URLs by vBSEO 3.6.0
All times are GMT +11. The time now is 10:44 AM.