Results 1 to 2 of 2
Like Tree4Likes
  • 3 Post By DEATHGUYJ
  • 1 Post By JWH

Thread: project flatop e-mech

  1. #1
    AVF Regular
    Join Date
    Jun 2013
    Location
    S.A. para hills
    Posts
    2,911

    Lightbulb project flatop e-mech

    well I hate that damm way too long 510 on my emech so i have deicided to make a flat top version this is a w.i.p.

    the first step is too disassemble the e-mech which is pretty easy a bad solder join on the negative connection broke while I was taking it apart. I have then desoldered the 510 from the e-mech board and removed the spring loaded center pin to use on my custom 510



    the next step is to take a generic 510 connector and cut it down as far as the base of the connection I used a pipe cutter after measuring the the amount I need to remove I then installed the spring loaded pin and held in the area it will be on the e-mech to make sure it's short enough and it is



    step 3 will involve me taking measurments and 3d printing a fitting to install my 510 into and fit it to the mechs shell

    I will update this soon
    Last edited by DEATHGUYJ; 27-10-14 at 12:07 AM.
    Robray, steve.c and nukem like this.

    aussie squonk box - the punisher - sig 100 watt - tesla series modded - vampire 26650 - modded chana - kamry 200 watt
    my etsy DEATHware

  2. #2
    JWH
    JWH is offline
    AVF Regular
    Join Date
    May 2011
    Location
    Perth, WA
    Posts
    1,650
    Handy having a printer like that
    Loving the stand man , sturdy as hell
    DEATHGUYJ likes this.

 

 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Powered by vBulletin® Version 4.2.4
Copyright © 2019 vBulletin Solutions, Inc. All rights reserved.
Search Engine Friendly URLs by vBSEO 3.6.0
All times are GMT +11. The time now is 12:02 AM.