Results 1 to 6 of 6
Like Tree1Likes
  • 1 Post By DEATHGUYJ

Thread: Hana Modz - Remove 510 Connector HELP!

  1. #1
    AVF Regular
    Join Date
    Mar 2014
    Location
    Zetland, Sydney
    Posts
    483

    Hana Modz - Remove 510 Connector HELP!

    Hi All!

    So I want to strip the anodising off my genuine Hana Mini (I know!), but I'm bored of the colour and I want to strip it back to bare alumnium and polish her up.

    I've taken all the hot glue off, but have no clue how to take the 510 connector off. I looked around but nothing decisive but it looks like it could be pressed on?? I've taken a pic.

    Thanks heaps guys. I plan to strip the paint off by using drain cleaner.

    Cheers


  2. #2
    AVF Regular
    Join Date
    Jun 2013
    Location
    S.A. para hills
    Posts
    2,911
    im pretty sure its pressed and glued in place i just drilled mine out but im replacing it with a fat daddy 510 you could try a solvent like acetone to melt the glue and lots of heat from a heat gun and tap it out from the bottom but you will likely damage the connector

    aussie squonk box - the punisher - sig 100 watt - tesla series modded - vampire 26650 - modded chana - kamry 200 watt
    my etsy DEATHware

  3. #3
    AVF Regular
    Join Date
    Mar 2014
    Location
    Zetland, Sydney
    Posts
    483
    How did you drill it out, from the bottom?

  4. #4
    AVF Regular
    Join Date
    Sep 2011
    Location
    Grumpy Old man, Living inPerth Northern suburbs
    Posts
    6,590
    I have had some success removing stuff that has been epoxied in place with heat from a hot air gun or the wifes hair drier. With applied heat, the epoxy softens, leaving the door open for removal of the component.
    Because I trust no-one Who tells me FACTS with no proof

  5. #5
    AVF Regular
    Join Date
    Mar 2014
    Location
    Zetland, Sydney
    Posts
    483
    Thanks Robray, but did you just tap it out from the bottom with a hammer, or does the top of the 510 screw out?

  6. #6
    AVF Regular
    Join Date
    Jun 2013
    Location
    S.A. para hills
    Posts
    2,911
    it's press fit so just knock it from the bottom with some thing heavy that will fit in there or if you have a small hammer and I drilled mine out from the top with a 6.5 then a 9mm drill bit and tapped it so I can screw the fat daddy into it
    Micdeez likes this.

    aussie squonk box - the punisher - sig 100 watt - tesla series modded - vampire 26650 - modded chana - kamry 200 watt
    my etsy DEATHware

 

 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Powered by vBulletin® Version 4.2.4
Copyright © 2019 vBulletin Solutions, Inc. All rights reserved.
Search Engine Friendly URLs by vBSEO 3.6.0
All times are GMT +11. The time now is 11:34 PM.