Results 1 to 3 of 3
  1. #1
    AVF Newbie | Be nice to me
    Join Date
    May 2014
    Albion park NSW Australia

    Rebuilding kanger subtank mini occ coils with nickel

    So tonight I decided to try rebuilding a occ coil with nickel the results are amazing there better than a pre built nickel coil hands down . Massive flavour , higher wattage vape and steady temps .

    Items needed

    An old occ coil head

    Vapowire 30g pure nickel .... 5 or so inches to work with

    Kanger organic cotton cut into approx 6mm wide strip

    3mm drill bit fits perfectly through the juice holes in the occ head



    Look up rip trippers occ rebuild video on YouTube to see the technique

    Use a 6 wrap coil which comes out around 0.18 once broken in

    Be patient take your time and u will have a 100% cloud and flavour monster that's rock solid on an rdna device for a lot less money than the prebuilt heads !

    Good luck !

    Nick v

  2. #2
    AVF Regular
    Join Date
    Apr 2013
    Perth (NOR)
    Can't wait to give this a go with my Nano, been rebuilding EVOD and T3s heads long enough.

    *Just spent 20 mins on the floor looking for the grain of sand sized ball bearing that likes to fall out of the air flow controller though! :O

  3. #3
    AVF Newbie | Be nice to me
    Join Date
    Jun 2015
    I've just received some 28g nickel and was about to rebuild my rba until I stood on it...
    Now I'm going to try it on the OCC coils and see how i go. Is there a calculator I can use to work out my wraps for this? I was just going to straight copy a standard nickel coil I have but im not sure if I have the same gauge.

    Sent from my SM-G900I using Tapatalk



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
Powered by vBulletin® Version 4.2.4
Copyright © 2019 vBulletin Solutions, Inc. All rights reserved.
Search Engine Friendly URLs by vBSEO 3.6.0
All times are GMT +11. The time now is 09:14 AM.