Hi,

I just received my $25 pair of pre made fused clapton coils. I tried to line them up with my new Mad Hatter RDA. They are too narrow to fit comfortably without bending the coil legs out to reach the posts. Each of the two hole posts of the Mad Hatter RDA, are on opposite sides of the outer limit of the inside of the RDA. The two holes of each post are one on top of the other. The posts are quite close to the cap when it is pushed on. The gap between them is too wide for the coil legs to slide straight into the post holes. My question is, can I bend the coil legs out to line up with the post holes, or would this create a bad coil. Please help. Thank you,
Toe.