Results 1 to 1 of 1
  1. #1
    AVF Regular
    Join Date
    Aug 2014
    Sydney (or lurking in the shadows behind you)

    Kepler 510 Finned Heat Sink for Atomizers

    (Note Thumbnails, click for bigger picture)

    I recently grabbed one of these form a well known Chinese Clone retailer.
    So I thought I might give ever one a heads up on the the good & the bad about these.

    Now first the Bad
    1. The air channel cuts are sharp, (owch type sharp), avoid the ones with air channel cuts until they fix it!
    2. The screw that goes down inside the top of this was in the bag, and it's a PITA to get it in place. A spot of blutac helped.
    3. The top screw needs to be unscrewed so much, to contact your Atty it gets a bit wobbly.
    4. The bottom screw & insulator need to be pushed up, so the bottom screw is at lest flush. A hammer & an old carto might work here.
    5. Their is no air flow for bottom breathing Atty's. You need to drill some holes.
    6. Only two sizes at present; 22mm & 30mm.

    Now the Good
    1. If you have an ever sinking 510 pin, problem solved.
    2. If you have buttery soft 510 threading, problem solved.
    3. If you are worried about your dripper over heating your PV, get the copper one, (SS & Aluminum are heat conductors, copper sucks up heat).
    4. Price: they are cheap as chips

    Three & a half stars out of ten.
    If you have the tools & where with all to fix them, go for it!
    If not avoid them!
    Last edited by Snidely_Whiplash; 20-01-15 at 11:07 AM.

    I Do Whatever I Want,
    Whenever I Want,
    And If It Doesn't Suit You,
    Go Start Your Own Empire

    Anything I write on this Forum is purely my opinion and should never be read as fact!
    (or I could just be wrong)
    Please read the Forum rules
    (or wait for Johnny Depp to do the movie)
    Small reminder
    It's all about the cigartte ... Stupid



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
Powered by vBulletin® Version 4.2.4
Copyright © 2020 vBulletin Solutions, Inc. All rights reserved.
Search Engine Friendly URLs by vBSEO 3.6.0
All times are GMT +11. The time now is 06:29 PM.